Menu
Walls are printed with all the plastic put down in parallel to the outside edge but I can only print walls along the edges. This works but I see a way it could be lighter and stronger. Currently I find I need to print it with 2mm walls and 2mm top and bottom thickness then 40% infill and the part is strong enough. Let's say it is a motor mount plate and have 7 bolt holes. I am printing a structural part and strength to weight is important. I want to do something, perhaps it is impossible with Cura.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |